Steps
1. Press the release latch to open the fan shroud.
2. Loosen the two captive screws and lift the heat sink away from the UltraSpeed Duo card.
3. Remove the screw (M2x3) from the UltraSpeed Duo card.
4. Peel the protection film that covers the thermal pad on the M.2 solid-state drive slot.
5. Peel the protection film that covers the thermal pad on the heat sink.
6. Align the notch on the M.2 2280 solid-state drive with the tab on the solid-state drive slot.
7. Slide the M.2 2280 solid-state drive into the M.2 2280 solid-state drive slot on the UltraSpeed Duo card.
8. Replace the screw (M2x3) on the UltraSpeed Duo card to secure the M.2 2280 solid-state drive.
9. Align the screw holes on the solid-state drive heat sink with screw holes on the UltraSpeed Duo card.
10. Tighten the two captive screws that secure the solid-state drive heat sink in place.
11. Close the fan shroud and press until it clicks in place.
Removing and installing components
75
To Next Page
Loading...
