Delta AS Series - Procedure for Creating a Project in Ispsoft

6.2 Procedure for Creating a Project in ISPSoft
This section shows you the procedure for creating a project in ISPSoft. You can adjust the procedure
according to your needs.
 Hardware configuration
You set the parameters such as a range of latched devices and a port number in a PLC. You configure
the modules with an AS Series CPU module, and set the parameters in these modules.
 Network configuration
If a system uses a network architecture, or devices need to exchange data, use the network configuration
tool
NWCONFIG
in ISPSoft to configure a network and exchange data with COM as well as Ethernet.
 Programming
After you write a program in ISPSoft, compile the program. If the compiling is unsuccessful, messages in
the
Compile Message
page show where the errors occur.
 Testing and debugging
Download the compiled program, the hardware configuration, and the network configuration to a PLC.
You can then test and debug the program online with the functions provided by ISPSoft.
Because the example introduced in this chapter does not discuss a network configuration, you only perform
the following procedure.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com