Delta AS Series - Ethernet Port Advance Setting - IP Filter; Ethernet Port Advance Setting - NTP

8.2.9 Ethernet Port Advance Setting – IP Filter
IP Filter
sets the filter function of network devices. Devices whose IP addresses are listed in the table are allowed to
communicate with the CPU module; the CPU module discards data packets sent from devices whose IP addresses
are not in the table. Devices on a network are filtered. This setting ensures that objects communicating with the CPU
module are known devices. You can set up to 8 address ranges for allowed devices.
Select
IP Filter Function Enable
checkbox to enable the IP filter function and type the start address and end address
of group 1~8 IP.
8.2.10 Ethernet Port Advance Setting – NTP
You can use
NTP
table to enable the CPU module and adjust time via NTP server. Relevant parameters are set here.
For more information on NTP, refer to related literature and manuals.
 Select
NTP Client Function Enable
checkbox to enable the function.
 Set the address of NTP server and cycle of constant update. Take the figure above as an example. The CPU
module connects to the NTP server every 30 minutes.
 Set up the time zone for the daylight saving time area.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com