Name: Delta AS Series
Brand: Delta
Rating: 5 (1 reviews)

To Next Page

To Previous Page

8.2.5 System Settings – Position Control Parameter

The parameters on

Position Control Parameter

table set to specify input points as the positive and negative limits of

axis 1~ axis 6 channels. 12 limit points can be set at most. Axis No. 1~6 can also be set as Z phase triggers, home

function finish points and clear output selects or positive/negative limited position.

 Axis1 (Y0.0/Y0.1) Positive/negative Limited Select ~ Axis 6 (Y0.10/Y0.11) Positive/negative Limited

Select.

Select the rising or falling edge trigger and X input point on the drop-down list.

 Axis1 (Y0.0/Y0.1) Z Phase Trigger ~ Axis6 (Y0.10/Y0.11) Z Phase Trigger

Select the rising or falling edge trigger and X input point on the drop-down list.

 Axis1 (Y0.0/Y0.1) Home Function Finish and Clear Output Select ~ Axis6 (Y0.10/Y0.11) Home Function

Finish and Clear Output Select

Select the rising or falling edge trigger and X input point on the drop-down list.

 Axis1 (Y0.0/Y0.1) Positive/negative Limited Position ~ Axis6 (Y0.10/Y0.11) Positive/negative Limited

Position

Set up the number of pulses as the positive or negative limited position in axis 1~6; setting range is -

2147483647

～

2147483647.

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

Other manuals for Delta AS Series

Questions and Answers:

Need help?

Do you have a question about the Delta AS Series and is the answer not in the manual?

General