24
3.2.8 Continue Start Permission (output): Selectable by I/O hardware setting
Terminal #53 on CN5 (port 24) is assigned a user output by factory default. It
can be assigned the Continue Start Permission output signal with the I/O
hardware setting.
When the "Continue Start Permission" is set:
(1) Function
The controller will output this signal when Continue Start is permitted.
(2) Terminal number
#53 on connector CN5
(3) Usage
Use this signal when you want to know whether Continue Start is permitted.
(4) ON condition
This signal comes on when Continue Start is permitted. For details, refer to
the SETTING-UP MANUAL, Chapter 3, Section 3.4.5 "Continue Function."
(5) OFF condition
This signal goes off by carrying out the "Task Status Change Operation."
To Next Page
Loading...
