Chapter 17: EQ 143
Configuring Graphic EQs
To configure the number of Graphic EQs:
1 Put the system into Config mode.
2 Go to the Options page and click the System tab.
3 Click the Edit button on-screen.
4 Choose the number of Graphic EQs from the pop-up menu.
You can choose to dedicate processing resources to provide 0,
8, 16, or 24 Graphic EQs.
Inserting Graphics EQs on Outputs
To insert a Graphic EQ on an Output bus:
1 Target the bus by pressing its Select switch.
2 In the Outputs page, click the 31-Band Graphic Equalizer tab.
3 Click the Graphic EQ pop-up menu and choose an available
mono or stereo Graphic EQ.
The 31-Band Graphic EQ appears on-screen.
Graphic EQ Controls
Input faders 1-16 provide control of Graphic EQ frequency
bands. You can also adjust graphic EQs on-screen.
To enable the graphic EQ:
1 Target an Output bus with a Graphic EQ assigned. If no
graphic EQ is assigned, display the 31-Band Graphic Equalizer
tab in the Outputs page and assign one using the Graphic EQ
pop-up menu.
2 Click the In button on-screen to toggle in/out status. When
enabled, the In/Out switch LED lights.
To set a graphic EQ curve:
1 Press the Graphic EQ band switch or click on-screen to select
the appropriate bank of graphic EQ bands: (20 to 630 Hz,
800 Hz to 20 kHz). Inputs 1–16 are temporarily replaced with
frequency fader controls.
2 Adjust one of the 16 faders controlling the selected graphic
EQ bands.
3 Press another Graphic EQ band switch or click on-screen to
select another bank of graphic EQ bands and adjust as needed.
To adjust graphic EQ gain:
Press the GEQ 800–20kHz switch, then adjust the last en-
coder above that bank of GEQ faders, or use the on-screen
Output control.
Resetting Graphic EQ Parameters
To reset a band to its default setting, do one of the following:
• Hold the Default switch and press the Select switch on
the fader corresponding to the graphic EQ band.
• Right-click the individual band fader on-screen and
choose Reset.
• Alt-click the band on-screen.
To reset the entire graphic EQ to flat:
Right-click anywhere in the Graphic EQ section on-screen
(but not directly on a fader) and choose Reset GEQ Section.
Configuring the number of Graphic EQs
Assigning a graphic EQ (mono)
31-band graphic EQ
31-Band Graphic Equalizer tab
Input fader banking and assignment switches
To Next Page
Loading...
