IntroductionModel 2500 12
© 2015-2017 Distek, Inc. All Rights Reserved
1.3 Notices
© Distek, Inc. 2015-2017
No part of this document may be reproduced in any form or by any means without written
consent from Distek Inc., as governed by United States and/or International copyright laws.
Manual Part Number
3825-0001
Document Revision History
Initial document created.
Changes with the following items:
1. Electrical power requirements
2. Added step to lower drive head
3. Added functionality: back light, touch tone and tablet dropper
Waters HPLC serial controls were updated.
Update RPM accuracy specification.
Changes with the following items:
1. Manual Run > In 'Note' added feature to change RPM during test
2. Create a New Method > Added method parameter for Infinity Sampling
3. Method Run > In 'Note' added Lot and Batch identification entry for
operator at beginning of test
4. Selecting a Method > Added command button for importing and
exporting methods
5. Report Summary > In 'Note' added feature for exporting reports
6. User Setup > Change user access permission for System Setup and
Instrument Validation
7. System Setup > Added feature parameter for changing user interface
language
8. Advanced > In 'Note' added feature when External Control is set for
Waters to display a vial icon
9. Advanced Setup > Update the parameters: IP Address, Subnet Mask and
Default Gateway
1. Update the following items to include 2500RTD as an option:
Instrument Overview
Instrument Specification
Notices
Installation of RTD shaft
Added 2500RTD Dashboard section
Update Create Method section
Update System Settings section
Added Battery Monitor section
2. Update LCD calibration login screen feature
3. Update Report screen functions
4. Update Appendix A
Update to include 2500SEL
To Next Page
Loading...
