Distek 2500 - Vessel Covers

To Next Page

To Previous Page

InstallationModel 2500 38

2.9 Vessel Covers

There are multiple cover designs you can use with the Model 2500 to minimize evaporation. All

Distek vessel covers place the sampling probes at the precise sampling height as per USP, BP, EP

and JP standards, the midpoint between the top of the stirring element and the top of the media.

Below are examples of different vessel covers.

Standard

Easy Basket Access

Sample Dropper

Opt-Diss Arch Probe

To install the vessel cover, open by slightly folding the cover until you can slide the vessel cover

over the shafts. Turn them so that the holes for the probes are located towards the front of the

instrument. This will enable you to access and position the probes easily before and after each

test.

Other manuals for Distek 2500