IntroductionModel 2500 14
© 2015-2017 Distek, Inc. All Rights Reserved
1.4 Safety Information
The following general safety precautions must be observed during all phases of operation, repair
and service of this instrument. Failure to comply with these precautions or warnings elsewhere
in this manual violates the safety standard of the design, manufacture and intended use of this
instrument. Distek Inc. assumes no liability for the customer or end-user to comply with these
requirements.
Operation
Before applying power, make sure the instrument complies with the installation requirements.
Additionally, the following must be observed:
Do not remove instrument covers when operating.
Instrument must be connected to a protective earth ground socket. Any interruption of the
protective earth grounding will cause a potential shock hazard that could result in serious
personal injury.
Make sure that only fuses with the required current rating and of the specified type are used
for replacement.
Any service should be only carried out by a skilled person who is aware of the hazard involved
and properly trained in the service and repair of the instrument.
Do not replace any components with power cable connected.
Do not operate the instrument in the presence of flammable gases or fumes.
Do not install substitute parts or make any unauthorized modification to the instrument.
Safety Symbols
WARNING: This symbol denotes a hazard. It calls attention to the
operating procedures and safety practices to prevent injury to personnel.
HIGH VOLTAGE: This symbol denotes the presence of high voltage.
CAUTION: This symbol denotes a hazard. It calls attention to the
operating procedures and safety practices to prevent damage to
equipment.
NOTES: This symbol denotes helpful information.
To Next Page
Loading...
