TroubleshootingModel 2500 192
© 2015-2017 Distek, Inc. All Rights Reserved
Check for drive belt integrity and proper tension. Replace or
adjust tension if necessary.
N oise fr om the D rive
a ssembly
Check for drive belt integrity and proper tension. Replace or
adjust tension if necessary.
Lubricate belts with a small amount of high vacuum grease on the
drive belts. Refer to Maintenance: Lubrication.
Inspect the the two ball bearings inside the spindle for wear. If a
clicking noise or grinding is heard while the spindles are
spinning, replace the spindle assembly.
Inspect the idler wheel integrity and check for wear. Replace the
idler wheel if necessary.
Check for drive belts integrity and proper tension. Replace or
adjust tension if necessary.
Lubricate belts with a small amount of high vacuum grease on the
drive belts. Refer to Maintenance: Lubrication.
Check the drive motor integrity. Make sure it does not stutter at
low speed. Replace the motor if necessary.
Check the pulley's integrity and be certain that it is securely
fastened.
Inspect the idler wheel integrity and check for wear. Replace the
idler wheels in pairs if necessary.
Inspect the the two ball bearings inside the spindle for wear. If a
clicking noise or grinding is heard while the spindles are
spinning, replace the spindle assembly.
Make sure that there is no other equipment or instruments that
can produce excessive vibration when they are turned on
(filtration, air conditioning, shakers, hood vents, etc.)
To Next Page
Loading...
