Troubleshooting Guide
SmartDate X40 BFSE Version 1.0 Feb 2011
137/286
Temperature problems
1500
Printer over temperature fault
Power off and allow cooling. Review operation.
Fault active when temperature rises above 85°C
Fault clears when temperature falls below 83°C
1501
Controller over temperature fault
Power off and allow cooling. Review installation.
Fault active when temperature rises above 75°C
Fault clears when temperature falls below 73°C
1502
Printhead over temperature fault
The Printhead is overheating, try reducing the
print darkness level. The Printhead thermistor or
Printhead may be damaged.
Fault active when temperature rises above 70°C
Fault clears when temperature falls below 57°C
Faults marked
*
will display an additional information to provide information of the exact cause
of the fault.
Potential Causes of Printer Hardware Fault
• Printer PLD Load Fail
Potential Causes of Software Fault
• Could not send an image to Printer
• Unspecified imaging fault
Note: The table above is a guide to what will appear on the user interface display. The
exact wording may vary.
To Next Page
Loading...
