Troubleshooting Guide
SmartDate X40 BFSE Version 1.0 Feb 2011
147/286
End Border
• This setting is the time allowed after the Printhead has finished printing before it
begins to move to the home position.
• This parameter should be set to the lowest value possible that maintains print
quality.
Note: Increasing this value will add to the overall cycle time.
Default - 0.5 mm
Head In Time
• This is the time allowed for the Printhead to stop pressing the ribbon against the
substrate.
• This setting is rarely changed.
Default - 5ms
To Next Page
Loading...
