Installation
SmartDate X40 BFSE Version 1.0 Feb 2011
64/286
• Insert this assembly into the mounting
hole of the partly assembled bracket
• Tighten the clamping screws for the
remaining two support bars, this will hold
the print roll assembly in place
• Fit the remaining end frame piece to the
bracket assembly making sure the
clamping screws are loose and that the
counter-bored holes face away from the
support tubes
• Make sure all 4 support tubes and the
pressure roller shaft line up with the
holes in the plate
• Using the soft faced mallet, gently tap
the plate until the ends of the tubes and the
shaft are approximately level with the frame
surface
• Check the ‘A’ dimension over the end plates,
and adjust plate positions as required
• Check that the end frame is at 90° to the
support tubes by using an engineer’s square
• When all adjustments are complete, tighten
the 4 screws
• Fit the plastic end caps to all of the support
tube ends, using Loctite 638 high strength
retainer to secure the caps to the tubes
• Attach the air regulator mounting assembly
to the completed bracket using the supplied
M5x10 button head screws. The position of
the air regulator assembly can be altered to
suit the application or the orientation of the
bracket
• Mount the encoder (Page 83)
To Next Page
Loading...
