Installation
SmartDate X40 BFSE Version 1.0 Feb 2011
65/286
Diverting Rollers
These are used in most applications to allow the print substrate to route through the
bracket assembly. There are 10 fixing holes around the end plate perimeter. Decide the
best combination of roller positions to suit the application. Each roller is made up of a tube,
2 bearing housings and 2 bearing pin assemblies.
• Cut the diverter roller tube to the length of ‘A’
dimension minus 75mm
• Assemble the tube and the 2 bearing
housings, applying Loctite 638 (high strength
retainer) to the side of the tube before pushing
the housing into position. Wipe away any
excess Loctite
• Loosely attach a bearing pin to the required
position on the end frame, use an M6x16
screw and apply a few drops of Loctite 242
(thread-locker) to the thread. Slide the roller
onto the bearing pin
• Fit the second bearing pin, complete with
collar, into the other end of the roller and
secure to the end frame as before
• Tighten each end, holding the bearing pin
stationary using an 8mm wrench and tighten
the screw using a 5mm hex key
• Centralize all the diverting rollers and fix them
in position using the collars on the bearing
pins. To secure the collars use a 2.5mm hex
key to tighten the screws
• Centralize the print roller using the collars on
the shaft. Use a 3mm hex key to tighten the
clamp screws
To Next Page
Loading...
