Installation
SmartDate X40 BFSE Version 1.0 Feb 2011
77/286
Assembly
• Layout and identify the parts supplied in the ‘L’ shaped modular kit
• Place one end frame onto a flat surface
ensuring that the counter-bored holes are facing
down and make sure that the 4 clamp securing
screws (M5x25) are loose
• Insert and secure 2 support tubes into the End
Frame Plate. A soft-faced mallet may be
required to ensure that the tubes are fully
inserted into the end-frame holes
• Tighten the clamping screws for the two support
tubes only, leaving the other two tubes loose.
This will enable the Print Roller to be fitted later
To Next Page
Loading...
