Overview
22 Instructions for use Carina SW 3.2n
Patient monitoring is supported by setting the fol-
lowing alarm limits:
– Airway pressure Paw high
– Minute volume MV high, MV low
– Respiratory rate RR high
– Time until disconnection alarm Tdiscon
– Apnea alarm time Tapn
Gas supply
An internal turbine supplies Carina with ambient air.
O
2 supply
– High Pressure Oxygen (HPO) from the central
gas supply system or from compressed gas cyl-
inders
– Low Pressure Oxygen (LPO) from an external
low-pressure oxygen source, e.g., O
2 concen-
trator
Power supply
– Mains power supply 100 to 240 V and 50/60 Hz
– Internal battery
– External battery (optional)
The active power supply is displayed on the screen.
Data transfer
The RS232 COM port can be used for data transfer
via the MEDIBUS or MEDIBUS.X protocol.
Medication nebulization
An external medication nebulizer is also optionally
available.
Trolley
Carina can be placed on a trolley.
An optional gas cylinder holder can be attached to
the trolley.
Bed and wall mountings
Optional bed and wall mountings are available for
fixing Carina to a bed or wall.
To Next Page
Loading...
