Assembly and preparation
48 Instructions for use Carina SW 3.2n
Connecting the power supply
Safety information for power supply
The device can be powered by the mains power
supply or an external battery for stationary use.
Both power sources charge the internal battery.
When the device is connected to both mains power
supply and the external battery at the same time,
the device is run on mains power. The external bat-
tery connection is switched off. The internal battery
is charged from the mains.
Mains power supply
The device is designed for connection to the hospi-
tal's mains power supply. Connection characteris-
tics, see "Operating data characteristics"
on page 130.
1 Plug the power cable (A) into the socket (B) and
secure it with the wire clip.
2 Insert the mains plug into the mains power
socket (C).
The LED flashes or lights depending on the
charge of the internal battery.
The device mains plug must be easily accessible to
ensure that the device can be disconnected from
the power supply at any time.
WARNING
Trip hazard
Position cables safely. Avoid trip hazards.
NOTE
Only use power cables with the following connec-
tors:
– The connector to the device conforms to the
IEC 60320-1 C17 or C13 standard and can be
secured by a wire clip.
– The mains plug conforms to the national regu-
lations.
010
To Next Page
Loading...
