Dräger Carina

Configuration
88 Instructions for use Carina SW 3.2n
Overview
The following settings can be made in the Config.
menu:
– Service
– System time
– Language
– MEDIBUS protocol
– Flow reduction (Anti Air Shower)
– Alarm volume
– Screen display of waveforms and measured
values
– Setting of measured value display
–O
2 supply with LPO mode or HPO mode
– Selection between non-invasive ventilation
(NIV) and invasive ventilation (Tube)
– Selection of setting of Ti or I:E
– Night mode On/Off
Settings made in the Config. menu are retained
when the device is switched off.
The following information about the device can be
called in the Config. menu under Service:
– System information
– Information on contacting DrägerService
– Logbook for technical alarm messages
Opening the configuration menu
1 Press the Select Menu (A) key.
2 Press the Config. (B) key.
The configuration menu shows the configurable
functions and parameters.
To display additional configurable parameters:
3 Press the (C) key.
110
A
BC
1
2
3
4
Menu 1 Service For system information, con-
tact information,
logbook
additional settings
Volume Alarm volume adjustable
from 1 to 5
Screen For selection of the display of
waveforms or values
Menu 2 Set
value
For selection of the meas-
ured values for the display of
Value 1 and Value 2
Method For selection of non-invasive
ventilation or invasive venti-
lation
O
2
suppl.
For selection of the O2 sup-
ply with LPO or HPO
Ti / I:E For selection of the used set-
ting for Ti or I:E ratio
Menu 3 Night For switching night mode on
or off
1
2
3
4
1
2
3
4
1
2
3
4