Dräger Fabius Tiro User Manual

Monitoring
118 Instructions for use Fabius Tiro SW 3.n
Setting the O2 alarm limits
The standard alarm limits configured for the
ventilation mode can be used unchanged, see
chapter ''Restoring the factory settings'' on page
135.
or
The alarm limits can be set individually for the
current case:
1 Press the (A) key.
The dialog window with the alarm limits (B) opens.
2 Adjust the upper and lower alarm limit values of
the O
2 concentration (C), see setting ranges of
alarm parameters in chapter ''Changing the
alarm limits'' on page 134.
3 Confirm new values.
Calibrating the O2 sensor
The O2 sensor must be exposed to the ambient air
during the entire calibration. The calibration of the
O2 sensor is done in the scope of the daily
checkout of the readiness for operation of Fabius.
The O
2 sensor can be calibrated in the following
ventilation modes:
–In Standby mode, see chapter ''Calibrating the
O
2 sensor'' on page 127.
– During the ventilation (in all available
ventilation modes), see chapter ''Calibrating
the O
2 sensor'' on page 141
2159021782
A
Volume Control
B
C

Dräger Fabius Tiro Specifications

General

Brand	Dräger
Model	Fabius Tiro
Category	Medical Equipment
Language	English