Instructions for use Fabius Tiro SW 3.n 53
Assembly and preparation
Before first operation
Activating the battery
To prevent discharging of the battery during
transport and during storage, the fuse of the
battery is not connected with the device.
1 Remove the battery fuse from its packaging.
2 Remove the fuse holder.
3 Insert the fuse (A) in the fuse holder.
4 Screw the fuse holder back in again with a
quarter turn clockwise.
Connecting the mains power supply
The mains voltage must correspond to the voltage
range indicated by the rating plate on the rear of
the device:
100 V to 240 V
WARNING
Risk of device malfunction
If the battery is not sufficiently charged and
the mains power supply fails, operation
cannot be maintained long enough.
Before first operation or after storage, charge
the battery for at least 8 hours.
WARNING
Risk due to reduced power supply from the
internal battery
Batteries are wear parts. The capacity of the
battery diminishes with the period of use.
Check the functional state of the battery by
performing preventive maintenance on a
regular basis.
21017
20951
WARNING
Risk of electric shock and device malfunction
If the device is connected to a power socket
with incorrect mains voltage or without a
protective ground, the user can be injured
and the device damaged.
Only connect the power cable to power
sockets with a protective ground, see
''Technical data''.
To Next Page
Loading...
