Technical data
206 Instructions for use Fabius Tiro SW 3.n
Device combinations
This device can be operated in combination with
other Dräger devices or with devices from other
manufacturers. Observe the accompanying
documents of the individual devices.
If a device combination is not approved by Dräger,
the safety and the functional state of the individual
devices can be compromised. The operating
organization must ensure that the device
combination complies with the applicable editions
of the relevant standards for medical devices.
Device combinations approved by Dräger meet the
requirements of the following standards (as
applicable):
– IEC 60601-1, 3rd edition (general requirements
for safety, device combinations, software-
controlled functions)
– IEC 60601-1-2 (electromagnetic
compatibility)
– IEC 60601-1-8 (alarm systems)
Or:
– IEC 60601-1, 2nd edition (general
requirements for safety)
– IEC 60601-1-1 (device combinations)
– IEC 60601-1-2 (electromagnetic
compatibility)
– IEC 60601-1-4 (software-controlled
functions)
– IEC 60601-1-8 (alarm systems)
Connections to IT networks
Data can be exchanged in an IT network using
hard-wired and wireless technologies. An IT
network can be any data interface (e.g., RS232)
that is described in standards and conventions.
During operation, this device can exchange
information with other devices by means of IT
networks and supports the following functions:
– Display of waveforms and parameter data
– Signaling of alarms
– Service mode, access to logbooks
Information for connecting to an IT
network
Prerequisites
This device must only be connected to the network
by service personnel. The IT representative of the
hospital must be consulted in advance.
The following documents must be followed:
– Accompanying documents of this device
– Descriptions of the network interface
– Description of the network-based alarm
systems
To Next Page
Loading...
