Dräger Fabius Tiro User Manual

Troubleshooting
150 Instructions for use Fabius Tiro SW 3.n
Ventilator failure
Alarm VENTILATOR FAIL !!!
If the ventilator does not return to its initial state,
the alarm VENTILATOR FAIL !!! activates.
Only manual ventilation or spontaneous breathing
is possible.
No other ventilation modes can be selected.
In this case, proceed as follows:
1 Change to ManSpont ventilation mode.
2 Set the APL valve to position Man.
3 Set the APL valve to the desired pressure.
4 Fill the breathing bag, if necessary with the aid
of the O
2 flush key.
5 Manually ventilate the patient.
Bypassing the ventilator
In the following cases, the ventilator must be
bypassed so that the ventilation can be continued.
– The ventilator does not return to its initial state
after a malfunction.
and
– The spontaneous breathing mode cannot be
activated.
To bypass the ventilator, proceed as follows:
1 Set the On/Off switch on the rear of Fabius to
(off).
2 Set the On/Off switch back to (on).
Fabius restarts and performs a selftest. More
information on the selftest can be found in section
''Checking the readiness for operation'' on page
85.
1 Select ventilation mode ManSpont.
2 Set the APL valve to position Man.
3 Set the APL valve to the desired pressure.
4 Fill the breathing bag, if necessary with the aid
of the O
2 flush key.
5 Manually ventilate the patient.
Before starting the ventilation with an automatic
ventilation mode, contact DrägerService or the
authorized local service partner.

Dräger Fabius Tiro Specifications

General

Brand	Dräger
Model	Fabius Tiro
Category	Medical Equipment
Language	English