Dräger Fabius Tiro - Restoring the Default Settings

Instructions for use Fabius Tiro SW 3.n 131
Configuration
Closing the alarm logbook
 Select the input arrow (D) and confirm.
The screen changes to Standby mode.
Restoring the default settings
The default settings are restored in the following
cases:
– Switching Fabius on and off
– Performing the system test
– Pressing the softkey Restore Site Defaults
1 Press the Restore Site Defaults softkey (A).
The default settings are restored. The following
message is displayed using the standby softkeys
(B):
Site Default settings restored
The default settings can be adjusted on the
Standby Set-up screen. Adjustment of the default
settings is password-protected.
CAUTION
Risk of losing data
All data in the alarm logbook are cleared in the
following cases:
– Fabius is switched off.
– The system test is started in standby mode.
– The power supply fails.
21582
Standby
A
B
WARNING
Risk due to unsuitable ventilation settings
After the default settings are restored, check
whether the settings for the ventilation and
monitoring are suitable for the patient.