Rho 1012/1030 F Software
Name
Media family
Type: Plate ("board") or roll medium
Fig. 64 Type sub-tab
Depending on whether you press the Boards or R
oll Media button under
media type, different buttons appear on the
sub-tabs.
4.2.1 Plate m edia
The following functions are available if you press the Boards button:
Board Options You press the Continuous Feeding button if you use the automatic feed
table for serial printing. This enables you to feed in stacks of plate media in
automatic or semi-automatic mode.
Press the Manual Continuo
us Feeding button, if you use a registration table
and continuously feed a tr
ack with plate media manually.
Press the Mechanical Front Stop button when you are feeding in individual
plate media and push the plate m edia manually to the front stop of the printer.
With the Rows per Batch selection list field you specify the number of rows
after which the feed system is to carry out a forced stop. All the plates
already fed in are first printed completely and transported out of the printer.
Afterwards the measuring system reregisters new the plate edges of the next
batch in order to avoid measuring errors in the image positioning.
Using the Tracks s
election list field, you set the number of webs to be printed
next to one anot
her.
With the Board Alignment buttons, you can set whe ther the plate m edia are
positioned at the right- or left-hand stop.
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/1030 , Issued 07/2013 105 / 147
To Next Page
Loading...
