Durst Rho 1012 - Loading the Roll Medium (Heavy Roll Tool 30)

Rho 1012/1030 EOperation
10.3 Loading the roll medium (Heavy Roll Tool 30)
A roll medium is loaded consecutively in the following steps:
 Initiating loading procedure in the software
 Inserting roll medium on the loading side
 Inserting empty core on the unloading side
 Guiding roll medium through the printer
 Aligning the roll medium
 Setting the roll-end sensor
 Commissioning unwinding and winding units
10.3.1 Initiatin g loading procedure in the software
Load the desired media channel in the software. Ensure that Roll
Media and Heavy Roll Tool are activated in the media channel
(→ Page 104 / Managing media channels).
10.3.2 Inserting roll medium on the loading side
1. Move unwinding unit to the bottom position.
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/10 30 , Issued 07/2013 75 / 147