Durst Rho 1012 - Docking and Connecting the Stacking Unit

E Operation Rho 1012/1030
9.2 Docking and connecting the stacking unit
Fig. 35 Docking the stacking unit
1. Set the key switch at the printer to 2 (device-change position).
2. Slide the stack ing unit respec t ively into the guide of the printer.
3. First close the left-hand clamp
ing lock, then the right-hand one.
4. Connect the power and control cables.
5. Connect the compressed-air hose.
6. Set the key switch at the p
rinter to 1 (normal mode).
68 / 1 47 2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 101 2/103 0, Issued 07/20 13