Durst Rho 1012 - Heavy Roll Tool 30 (Optional); Docking Heavy Roll Tool 30

E Operation Rho 1012/1030
5.4.3 Adjusting the height of the inlet plates
1
Adjust the height of the inlet plates u sin g the crank (1).
6 Heavy roll tool 30 (optional)
6.1 Docking Heavy Roll Tool 30
The unwinding unit is docked on the loading side, and the winding unit is
docked on the unloading side in the same manner.
1. Set the key switch at the printer to 2 (device-change position).
54 / 1 47 2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 101 2/103 0, Issued 07/20 13