Rho 1012/1030 B Safety
Ink supply unit with Durst Cubitainer
Waste tank
Light trap carrier
Uncured inks on printed media due to insufficient UV exposure
Spray mist of ink droplets in case of large print head distance
Observe the safety data sheets supplied with the ink.
Operate the printer with Durst inks only.
Use only the cubitainers intended for the printer (→ Pa ge 146 / Accessorie s
and spare parts).
Wear protective gloves and safety goggles when cleaning the print
heads, adding ink or emptying the waste tank.
Avoid allowing ink to contact your face or eyes, e.g. by rubbing your eyes
with dirty hands.
If contact with the skin occurs, wash affected areas with pH-neutral soap
and water.
Carry out all specified inspection and cleaning work.
8.6 Sharp edges
Sharp-edged media and housing components can cause cuts.
Wear protective gloves when handling media.
Do not reach into the inlet and outlet openings during the printing process.
8.7 Ozone buildup
To prevent ozone from building up in the room, Durst recommends setting
up the external ventilator with a switch-off time delay. The switch-off time
delay should switch off the ventilator at least 10 minutes after the printer is
switched off.
The external exhaust equipment must be capable of extracting the required
minimum exhaust quantity (→ Page 143 / Technical data).
Do not switch off external ventilator for exhaust during printing.
8.8 Pneumatic system
The pneumatic circuits for generating a vacuum at the print head, conveyor
belt and ink transport are under pressure. Ink which is ejected suddenly from
leaky lines and connections or compressed air released suddenly from leaky
lines and connections can cause severe injury.
Ensure that the required service work is carried out regularly by Durst
customer service.
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/10 30 , Issued 07/2013 17 / 147
To Next Page
Loading...
