Rho 1012/1030 EOperation
1
2
3
Fig. 14 Automatic feed table overview
Automati c mod e
In automatic mode the plate media are stacked on each other. The
front stop
(2) keeps the plate media back. Only the lowest plate medium re
spectively
is transported through the gap between the front stop and the
conveyor be lt
to the printer.
Semi-automatic mode The front stop (2) is not used in semi-automatic mode. Pins (3) that travel
automatically upwards serve as a front stop. If drawing-in is triggered
manually, the pins travel downwards and enable transporting of the plate
medium.
Manual mode
The front stop (2) is not used in manual mode. In this operating mode the rolls
(1) move upwards. The plate medium is laid on the rolls of the feed table and
pushed manually on the rolls until the front stop of the printer.
3.2 Operating elements
1Rolls
2 Roll Up – Down button
3 Operator p ane l for semi-automatic
mode
1
2
3
Fig. 15 Operator panels
Semi-automatic mode One operator panel (3) each is located on the right- and left-hand side of the
feed table for semi-automatic mode.
The buttons have the following function:
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/10 30 , Issued 07/2013 37 / 147
To Next Page
Loading...
