Durst Rho 1012 - Switching on the Printer Again after an Emergency; Stop; Faults; Handling Faults

B Safety Rho 1012/1030
12.2.2 First aid in case ink con tacts s kin , mucou s memb ranes or
eyes
Wash affected areas with pH-neutral soap and water. Under no
circumstances should solvents be used, as it remove oils from the skin
and increase irritation.
Change your clothes immediately if heavy contamination has occurred.
If some spray has entered your eyes, wash your eyes immediately with
lots water and contact a doctor.
12.3 Switching on the printer again after an emergency
stop
12.3.1 Reactivating an Emergen cy-Stop switch
Turn Emergency-Stop switch to the right.
 Emergency-Stop switch pops out
13 Faults
13.1 Handling faults
If the printer stops unexpectedly:
– Switch off the printer with the Emergency-Stop switch and/or the
main sw itch.
– Notify the Durst customer service.
If a paper jam occurs, never reach under the housing covers with your
hand.
14 Avoiding damage to property
14.1 UV lamps
If the UV lamps are r eplaced improperly, these are damaged. The UV lamps
may only be replaced by Durst service technicians.
14.2 Print head maintenance
The print heads can be damaged if the ink dries out.
Carry out all prescribed maintenance work on the print heads.
20 / 1 47 2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 101 2/103 0, Issued 07/20 13