Rho 1012/1030 G Service
When? What?
Annually
Have print heads checked and, if necessary, adjusted by
Durst service technicians.
Change m a in ink filters (→ Page 127 / Changing main
ink filters)
Allow only Durst service technicians to check pneumatic
circuits.
When necessary
Clean housing of the printer (→ Page 127 / Cleaning
housing).
Remove leaked ink.
Clean conveyor belt.
Carry out print head maintenance (→ Page 130 / P rint
head maintenance).
Clean catch tray of scraping blade (→ Page 122 / Clean
catch tray of scraping blade).
In case of fault or defect Check fuses and, if necessary, have replaced by Durst
service technicians (→ Page 127 / Checking fuses).
2 Important information
Scattered light from the UV lamps reduces print quality. Scattered light may
be present in the following cases:
Black painted surfaces are scratched and th us take on a reflective
surface.
The light trap carrier is not installed.
Do not touch black painted surfaces with hard objects, e.g. knives.
Ensure that the light trap carrier is always installed.
Repaint discolored black painted surfaces on the transport system or
light trap with black paint.
3 Initialization after closing the flip doors
Onceyouhaveclosedtheflip doors after service work, you must reinitialize
the print carriage.
✔ The flip doors are closed
Initialize print carriag e in the software (→ Page 100 / Operating printer
functions).
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/1030 , Issued 07/2013 119 / 147
To Next Page
Loading...
