Durst Rho 1012 - Media Specifications; Workstation; Requirements for Installation Site

Rho 1012/1030 Appendix
1.3 Media specifications
Parameter Value
Rigid media Uncoated and coated plate media. Examples:
 Rigid-foam plates
 Flexible-foam plates
 Aluminum
 Acrylic glas s
 Polycarbonate
Minimum ignition
temperature
150 °C (302 °F)
Maximum printing
width
250 cm
Maximum printing
length
Limited only by medium length
Maximum medium
thickness
 Standard: 40 mm
 Industrial model: 70 mm
Minimum plate size
 For manual loading: DIN A3 (29.7 x 42 cm)
 Automation depending on loading unit
1.4 Workstation
Parameter Value
Operating system
Red Hat Enterprise L inu x
Connections  USB
 Ethernet: 100/1000 Mbps
1.5 Requirements for installation site
Parameter Value
Maximum altitude
2400 m (8000 ft) above sea level
Temperature range
+20 ℃ to +30 ℃
Relative humidity
25 to 80%, non-condensing
Hot air output/feed 4500 m
3
/h (158900 cu.ft./h)
Compressed-air connection 6 to 8 bar with 5 L/min (70 psi at 1.3 gal/min) (dry air only)
Exhaust quantity of the
exhaust equipment
Min. 1000 m
3
/h ( 35,315 cu.ft. /h)
Recommended: 2300 m
3
/h (8 1,224 cu.ft./h)
Illumination Min. 500 lx
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/1030 , Issued 07/2013 145 / 147