Rho 1012/1030 F Software
If the power level is too high, sensitive media can yellow or stretch. For this
reason, it may be necessary to not carry out full curing so as to protect the
medium.
In special cases, you will require more power. In such cases, it makes sense
to increase the power level and work with two UV lam ps.
Media Transport S pecifications Encoder Offset: If the advance causes striping during printing, you can enter
an encoder offset value. This value is added to or subtracted from the global
encoder offset value (General tab).
Feeding Offset: In the case of heavy plate media a small offset caan arise
during transporting into and out of the printer. You can compens a te this offset
by entering a value for Feeding Offset.
Feed Roll Distance: You can change the contact pressure on the medium
via the spacing of the transport rollers. With a value of "0", the contact
pressure is at its maximum.
Feeding Offset: If you are loading a flexible medium with rounded corners,
the optical sensor may detect the edge of the medium too late. This will
result in a printing offset. You can compensate for this offset by entering a
correction value.
Additional Options
When printing heavy media, striping may occur due to slippage between the
medium and the conveyor belt. You can minimize slippage with the Heavy
Weight button.
4.4 Print options
You can define the following parameters, among others, on the Print Options
sub-tab:
Quality level
Print direction
Surface
Print refinement and special effects
Spot colors
Curing delay
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/1030 , Issued 07/2013 107 / 147
To Next Page
Loading...
