Rho 1012/1030 EOperation
7.2 Operating drives of the unwinding and winding
units
7.2.1 Operating elements
1 START button
2 Lamp
3 FORWARD button
4 UP button
5Scale
6 Controller
7 Emergency-Stop switch
8 DOWN button
9 REVERSE button
10 Selector switch
11 LOAD button
1 2 3 4 5 6
11 10 9 8 7
Fig. 30 Operating elements
The drives of the unwinding and winding units are operated at the operator
panels, one of which is located on each of the right and left sides.
Position Button designation Function
1
START button
Activating the Heavy Roll Tool
60
2Lamp Lights up: Heavy Roll Tool
60 operating
Flashing: Fault (e.g. error
message or no medium
present)
3
FORWARD butt on
Transporting the roll medium
forward by hand
4 UP button Moving the roll mounts upward
5
Scale
Reading the horizontal position
6
Controller
Fine positioning the roll
medium horizontally
7
Emergency-Stop switch
Triggering an emergency stop
8
DOWN button
Moving the roll mounts
downward
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/10 30 , Issued 07/2013 59 / 147
To Next Page
Loading...
