Durst Rho 1012 - Page 58

E Operation Rho 1012/1030
1. Set the key switch at the printer to 2 (device-change position).
Fig. 29 Sliding the Heavy Roll Tool 60 into the guide and closing
the clamping lock
2. Slide the Heavy Roll Tool 60 into the guide of the printer.
3. Close clamping lock .
4. Connect power cable to the connect
or on the unwinding unit and to the
connector on the printer.
5. Connect the control cable to the connection on the unwinding and
winding un its.
6. Set the key switch at the printer to 1 (normal mode).
58 / 1 47 2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 101 2/103 0, Issued 07/20 13