E Operation Rho 1012/1030
Position Button designation Function
9
REVERSE butt on
Transporting the roll medium
backward by hand
10
Selector sw itc h Switching between the
following operating modes:
Manual: Manual mode
Auto Forward:Forward
direction of movement in
automatic mode
Auto Reverse: Reverse
direction of movement in
automatic mode
11
LOAD button
Moving the dancing rollers
upward
7.2.2 Commissioning winding and unwinding units
Carry out the following steps respectively at the winding and unwinding units:
✔ The winding and unwinding units are connected to the printer
1. Set selector switch to Manual.
2. Press the START button.
The lamp lights up
Power is supplied to the Heavy R oll Tool 60 and it can be operated.
7.2.3 Setting axis drives to automatic ope
ration
✔ Winding and unwinding units are operating
Depending on the desired rotation direction, set the selector switch to
Auto Forward or Auto Reverse.
7.2.4 Rotating axis drives forward and in reverse manually
✔ Winding and unwinding units are operating
1. Set selector switch to Manual.
2. Pres s and hold the FORWARD or REVERSE button as long as desired.
7.2.5 Mo ving the roll mounts upward or down ward
✔ Winding and unwinding units are operating
Danger of collision while moving up and down with opened roll mounts!
DamagetotheHeavyRollTool
Close the roll mounts before moving up or down.
60 / 1 47 2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 101 2/103 0, Issued 07/20 13
To Next Page
Loading...
