Dynon Avionics SkyView - Page 4

iv SkyView System Installation Guide - Revision K
Dynon Avionics retains the exclusive right to repair or replace the instrument or firmware or offer a full refund of the purchase price at its sole
discretion. SUCH REMEDY SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY FOR ANY BREACH OF WARRANTY.
These instruments are not intended for use in type certificated aircraft at this time. Dynon Avionics makes no claim as to the suitability of its
products in connection with FAR 91.205.
Dynon Avionics’ products incorporate a variety of precise, sensitive electronics. SkyView products do not contain any field/user-serviceable
parts. Units found to have been taken apart may not be eligible for repair under warranty. Additionally, once a Dynon Avionics unit is opened
up, it is not considered airworthy and must be serviced at the factory.
Revision History
Revision
Revision Date
Description
A
December 2009
Initial release
B
March 2010
Document number changed to 101320-001.
Minor style, grammar, and cross reference changes and
corrections.
Updated guide to reflect SkyView firmware version 1.5
behavior and requirements.
Added servo installation information in various chapters.
Clarified SV-ADAHRS-20X installation orientation
requirements.
Clarified SkyView display basic operation procedures.
Most notably, added a screen synchronization section.
SV-D700 / SV-D1000 Installation and Configuration
Chapter Updates:
 Called out the use of a 5 amp breaker instead of a
7.5 amp breaker on page 4-7.
 Added important backup battery information on
page 4-7.
 Consolidated serial device installation into this
chapter.
 Added installation information for external
dimming control and audio outputs.
 Expanded the Brightness Setup Section.
 Added a section regarding installed databases.
 Added a section reminding users outside of North
America that they will need to install an
applicable terrain database file on page 4-14.
 Added a section regarding Aviation Data.
Cautioned against the use of ferrous pneumatic fittings
on page 5-3.