SkyView System Installation Guide - Revision K vii
Added firmware upgrade information for servos being
used from D10/D100 with older firmware.
Clarified GPS serial connection wire functions and colors.
Added SV-XPNDR-26X installation instructions and
specifications.
Added SV-ARINC-429 installation instructions and
specifications.
Added new requirement to connect TX and RX lines from
serial devices to ALL displays in parallel.
Added information about Autopilot servos not needing
lubrication.
Clarified lack of boom mount AOA/Pitot mount
availability.
Clarified that cable-side transponder TNC connector is
not provided by Dynon.
Added SV-BAT-320 connection information for customers
making their own harnesses.
Added OAT connection information for customers
making their own harnesses.
Removed 30K resistor requirement for Rotax trigger coil
RPM pickup.
Clarified SV-GPS-250 connections when multiple displays
and/or SV-GPS-250 modules are involved.
Added pinout table for Dynon Capacitance-to-Voltage
Converter.
Added connector labels to SkyView Network Module and
Display Diagrams.
Fixed orientation of SkyView connectors on diagrams.
Clarified acceptable SV-ADAHRS-20X orientation.
Added additional Garmin 430 and SL30 configuration
information.
Fixed link to AOA information on Dynon web site.
Added LED status troubleshooting information for
SkyView modules.
To Next Page
Loading...
