vi SkyView System Installation Guide - Revision K
Installation and Configuration Chapter.
Added an important note on page 5-7 regarding the
necessity of configuring airspeed limitations for autopilot
servo calibration.
Specified that the SV-EMS-220 warning light pin (D37 pin
29) should not be connected in Table 15.
The SV-GPS-250 should now be configured as INPUT
FUNCTION = POS 1.
Clarified servo installation instructions regarding the
connection point on the servo arm with the linkage
hardware on page 9-6.
Updated the AP Disengage/CWS Button Section on page
9-10 to say that the button is required instead of just
highly recommended.
Document number changed to 101320-003.
Added GPS Fix Status information.
Added Fuel Flow pulses/gallon documentation.
Clarified EMS GP input compatibility.
Added information about obstacles and runways to
synthetic vision section.
Added information about new autopilot pitch axis
settings.
Added information about optional External Alarm Light
connection.
Added information about fuel computer settings.
Updated autopilot test procedures with additional
warnings and precautions.
Reiterated the importance of proper ADAHRS orientation
and other installation requirements.
Added note about servo self-lubrication.
Clarified lack of specific boom-mount AOA/Pitot
installation instructions.
Added information about serial device and display
connection requirements.
To Next Page
Loading...
