Dynon Avionics SkyView - Page 72

SV-ADAHRS-20X Installation and Configuration
5-2 SkyView System Installation Guide - Revision K
Figure 21 is a high-level overview of a suggested and installation and configuration procedure
for the SV-ADAHRS-20X.
Choose a
location based on
Location
Requirements
Section
Install SkyView
network cabling
Prepare the
location
Install AOA/Pitot
probe
Install static port
(not covered in
this guide)
Install pneumatic
plumbing
Install OAT probe
and wiring
Install ADAHRS
module with
electrical and
pneumatic
connections
Configure
ADAHRS-related
settings on
SkyView display*
Perform magnetic
calibration
Perform AOA
calibration
Reference
Accessory
Installation and
Configuration
Chapter
*Assumes SV-D700 or SV-D1000 is properly installed and working.
Configure
SkyView Network*
Figure 21–Suggested SV-ADAHRS-20X Installation Procedure