SV-BAT-320 can provide power to in the event of power
failure.
Added EI FT-60 fuel flow sensor orientation information.
Added a note about the importance of external devices
sharing ground with SkyView for proper operation.
Added Amps shunt fuse diagram.
Added SV-XPNDR-26X power wire size recommendation.
Added permission to print manual.
Added information about taking screenshots for
troubleshooting purposes.
Added information about re-doing ADAHRS-based
calibrations if an additional ADARHS is installed after
calibrations have been done.
Consolidated all information about ADAHRS calibrations
into the ADAHRS installation chapter.
Added ADAHRS, SYSTEM, and NMEA Serial output
information to Serial Data Output Appendix.
Added Garmin GTN connection information.
Added Garmin serial port setting for Garmin 430/530
ARINC-429 based connections.
Added information about equipping for IFR.
Clarified that Jeppesen data must be transferred to USB
stick via the Jeppesen JSUM program.
Added PocketFMS information.
Clarified Honeywell oil pressure sensor connection
information (Rotax).
Added recommendation to ensure master
contactor/relay is protected by a diode.
Clarified fuel flow sensor connections.
Added UMA differential pressure sensor information.
Added backup battery test to initial installation
procedures.
Changed EMS wire harness tables to indicate pin 2 may
To Next Page
Loading...
