DESCRIPTION AND INSTALLATION
25364 Issue 8 March 2018 2-17
Communicator II
Note: Refer to page 2-34 for Connection Diagram when connecting
the printer to the mains, peripherals and network.
• Connect the cable from the power supply to the printer
• Connect the printer cable between the printer and the I/O Box
• Connect the air pressure to the printer
• Set the regulator to approximately 2.5 bar / 0.25MPa (128mm Printer
3.5 Bar / 0.35MPa) so that the air pressure gauge reads either 2.5 Bar
or 3.5 Bar
• Supply the mains to the Power supply
• Connect the I/O to the host machine.
• If the printer is used in CM, connect the encoder to the I/O box
• If a Touchscreen is to be used, see “Touchscreen” on page 2-43.
To Next Page
