DESCRIPTION AND INSTALLATION
2-66 25364 Issue 8 March 2018
Install Options
• Hotstart - When the system is switched on, the Hotstart function (if
enabled) automatically tries to load the design that was loaded when
the system was last switched off
Note: Any counters and real time variables in the design are
re-initialised as they would be during a normal job load.
• Do not Display Out of Memory - The user can assign this setting if an
‘Out of Memory’ error displays
• Disable Complex Scripting - Complex scripting is required for
displaying Arabic text and is enabled as default. However, it makes
rendering of text quite slow (only noticeable for large text fields). To
change the setting, set or remove the tickbox and perform a
mandatory reboot of the printer. To verify if Complex Scripting is
enabled, a design with some Arabic text is required. When Complex
Scripting is enabled, the text is ‘correct’. When it is disabled, it is
‘incorrect’
• Auto Copy Designs - If a USB device containing design files stored in
the root directory is inserted into the printer, the user is asked if the
designs are to be copied to the internal store
• Auto Copy Fonts - If a USB device containing font files stored in the
root directory is inserted into the printer, the user is asked if the fonts
are to be copied to the internal store
• Abort print at low speed - The user can select to abort the print at the
speed below the set value by ticking the box
• Ignore Cover Sensor - This variable is available on Compact 32d only.
See “Ignore Cover Sensor” on page 4-3.
To Next Page
Loading...
