DESCRIPTION AND INSTALLATION
25364 Issue 8 March 2018 2-49
(5) Ensure that the print head is in the fully retracted position by manually
adjusting if necessary. Normally this is achieved automatically when
the cassette is removed with the power on and the printer has the
status ‘Printer open’.
(6) Fit the cassette to the printer.
(7) Push the latch closed to lock it.
CAUTION: If the latch is forced closed before the cassette is
fully inserted it may become damaged.
(8) Press the reset button. The printer initialises.
Note: If an audible clicking or banging noise is heard during
calibration, the ribbon is threaded incorrectly. Remove the
cassette to halt the calibration. Review the ribbon path
diagrams, then repeat the ribbon threading procedure until the
noise stops.
To Next Page
Loading...
