Acclarix LX9 Series Diagnostic Ultrasound System User Manual
2
Safety
Throughout this document the following terms are used:
Warning: Advises against certain actions or situations that could result in personal injury or
death.
Caution: Advises against actions or situations that could damage equipment, produce
inaccurate data, or invalidate a procedure.
Note: Provides useful information regarding a function or a procedure.
Please read all warnings and cautions prior to using the system. For your convenience, all warnings
and cautions are provided in this section, but may be duplicated elsewhere in this document in the
context of the instructions for use.
2.1
Warnings
Only use Edan supplied power cord.
Only use Edan supplied battery. Read and understand the battery installation instructions prior
to changing the battery.
Only use Edan supplied transducer. Use of other transducers may result in electric shock or
system malfunction.
Only use a hospital grade, grounded, power outlet and plug. Do not use with an ungrounded
outlet.
The system is ordinary equipment (Sealed equipment without liquid proof). The transducers
(not including the transducer connector) are IPX7 certified. The footswitch is IP68 certified. Do
not immerse or expose any of the parts to extended moisture. Splash resistance does not
extend to transducer connectors. Please keep connectors dry.
Do not use in a wet environment or when the relative humidity exceeds 95%.
Do not reverse the positive and negative poles when installing the battery.
Do not use the battery near heat sources or when the ambient temperature is over 40
o
C. Do
not heat or dispose of in fire.
Do not destroy the battery; do not pierce or cause a strong impact to the battery.
Do not touch the connector pins on the transducer port.
Parts and accessories used must meet the requirements of the applicable IEC/EN60601
series safety standards, and/or the system configuration must meet the requirements of the
IEC/EN60601-1.
Use protective barriers (FDA cleared/legally marketed gloves and transducer sheaths)
whenever possible. Follow sterile procedures when appropriate. Thoroughly clean
transducers and reusable accessories after each patient examination and disinfect or sterilize
as needed. Refer to transducer use and care instructions. Follow all infection control policies
established by your office, department or institution as they apply to personnel and equipment.
Not intended for Ophthalmic use or any use causing the acoustic beam to pass through the
eye.
If a sterile transducer cover becomes compromised during an intra-operative application
involving a patient with transmissible spongiform encephalopathy, such as Creutzfeldt-Jakob
disease, follow the guidelines of the U.S. Disease Control Center and this document from the