EDAN Acclarix LX9 Series User Manual

- 197
-
Acclarix LX9 Series Diagnostic Ultrasound System User Manual
Utilities
10.5.2. Application Parameters
On the Application Parameter page, you can configure the default measurement results of
Doppler trace measurement for each exam application. Select one clinic application in the
Application drop-down list, for example ABD, and then tick the measurement result items in the list
below. When you perform Doppler trace measurement, the system will display all the ticked result
items by default.
10.5.3. Measure Preset
On the Measure Preset page, you can configure the measurements for each exam preset in each
imaging mode. Follow the steps below:
1. Select exam application
Select an exam application, for example ABD, in the Application drop-down list.
2. Select exam preset
Select an exam preset in the Preset list, for example Abdomen.
3. Select imaging mode
Select an imaging mode in the Imaging Mode list, for example 2D.
4. Select measurements
In the Group list, select a measurement group, and all the measurement items included in this group
are displayed in the Measurement list. Now the following operations are allowed through the controls
on the right side of the screen:
 Add: Add measurement items to the selected measurement group. Clicking on Add
button will bring you a menu for selecting other measurement items.
 Edit: Set the default measurement tool and measurement result for the select
measurement item.
Note:
Cancel and Copy operation is not available for this release.
10.5.4. Report Set-up
The system supports a user-defined report header and report content.
You can import a logo and set the logo‟s position and size. Report logo settings are as follows:
 Import: import a bmp format logo from USB disk.
 Delete: delete the imported logo.
 Logo Position: set the logo position to locating at the left or right side of report header.
 Logo Size: set the logo size to Small or Large.
You can also select different exam contents to add to the report, and adjust the sequence and layout
of report contents.
The Report settings are as follows:
1. Set the report content: Select different exam contents to add to the report.
 Change Order: After selecting one exam content, press ↑ or ↓ to adjust its
sequence in the report.

EDAN Acclarix LX9 Series Specifications

General

Brand	EDAN
Model	Acclarix LX9 Series
Category	Diagnostic Equipment
Language	English