Acclarix LX9 Series Diagnostic Ultrasound System User Manual
4. Ensure the transducer is connected firmly and properly. This is to avoid bad contact between the
transducer and transducer socket.
5. Ensure that the system is shut down, or the image is frozen, before connecting and disconnecting
transducers.
3.3.4. Powering on/ off
Please review and follow the steps described in the Section 13.1.Daily Checklist prior to powering on
the system.
To power on
1. Connect the AC power supply.
Or, use the battery as the power supply.
2. Press the Power on/off key on the top left of control panel.
To Login
If Password Protection is enabled (see section 10.1.6), the system displays a Login dialog when
booting up the system. Type in or select user name from the User Name drop-down list, then
enter password and click Login.
For emergency use, click on Emergency to log on directly without entering user name and
password.
NOTE:
1. It is not suggested to use Emergency login under non-Emergency situation. Please login the
system with your account or switch to your account through the Switch User function (See
"To Switch Users" below) prior to imaging scanning.
2. Ensure the privacy of patient information and data created through Emergency login. It is
suggested to remove the patient exam data from the ultrasound system after Emergency
scanning for protecting patient data from being accessed by unauthorized users.
To Switch Users
If Password Protection is enabled, switching users is allowed without restarting the system.
1. Press Power on/off key, and the system will display a confirmation dialog box.
2. Select User from the confirmation dialog box. A login information dialog box will be displayed
providing access to change user.
3. Select Change User and this brings up the system login dialog box.
4. Select another user from the User Name drop-down list and then enter password to login.
To power off
1. Press the Power on/off key on the top left of control panel and the system displays a
confirmation dialog box.
2. Select “Shut Down” from the confirmation dialog box.
If the system is unresponsive, a long press of the Power on/off key will shut down the system
directly.
To Next Page
Loading...
Need help?
General
