Edge-Core ECS2020 Series - Change the Port Mode Is Hybrid

34
The steps to set port mode is trunk are as follows:
Step 1: Chose one or more ports;
Step 2: Click the port mode list chose the mode is: trunk;
Step 3: Set Native VLAN, the VLAN must be is exist;
Step 4: Set by allowing the VLAN number, the default allowed VLAN is empty, if you want to allowed the native
VLAN, you must be configure allowed the native VLAN;
Step 5: Click on the lower right corner of the "Apply" button to complete the configuration.
5.1.7 Change the port mode is hybrid
Select the port you want to change the mode and click the "Port Mode" list, you can set the port mode is hybrid:
Figure 5-9: Change the Port Mode is Hybrid
The steps to set port mode is hybrid are as follows:
Step 1: Chose one or more ports;
Step 2: Click the port mode list chose the mode is: hybrid;
Step 3: Set Native VLAN, the VLAN must be is exist;
Step 4: Set by allowing the VLAN number, the default allowed VLAN 1, if you want to allowed the native VLAN, you
must be configure allowed the native VLAN;
Step 5: Click on the lower right corner of the "Apply" button to complete the configuration.