91
7.8.2 Configure ROMN type
Configure ROMN type: Alarm, selected one port to configure and setting parameters and click "Apply" button.
Figure 7-35: Configure ROMN Type
Notice: Parameters There are some special rules in the configuration. The EVENT should be created first. Please note
the prompts in the configuration. eg: Rising Threshold is greater than Falling Threshold.
7.8.3 Change ROMN type
On the ROMN configure page, click the type "Event" or "History" and setting parameters. Be careful the parameter
of Community should be exit in SNMP Community name. Configure ok after clicking "Apply".
Figure 7-36: Change ROMN Type is Event
To Next Page
Loading...
