Edge-Core ECS4120-28F

Chapter 8 | Authentication Commands
PPPoE Intermediate Agent
– 272 –
Example
Console(config)#pppoe intermediate-agent format-type access-node-identifier
billibong
Console(config)#
pppoe intermediate-
agent port-enable
This command enables the PPPoE IA on an interface. Use the no form to disable this
feature.
Syntax
[no] pppoe intermediate-agent port-enable
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
PPPoE IA must also be enabled globally on the switch for this command to take
effect.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#pppoe intermediate-agent port-enable
Console(config-if)#
pppoe intermediate-
agent port-format-
type
This command sets the circuit-id or remote-id for an interface. Use the no form to
restore the default settings.
Syntax
pppoe intermediate-agent port-format-type {circuit-id | remote-id}
id-string
circuit-id - String identifying the circuit identifier (or interface) on this
switch to which the user is connected. (Range: 1-10 ASCII characters)
remote-id - String identifying the remote identifier (or interface) on this
switch to which the user is connected. (Range: 1-63 ASCII characters)
Default Setting
circuit-id: unit/port:vlan-id or 0/trunk-id:vlan-id
remote-id: port MAC address
Command Mode
Interface Configuration (Ethernet, Port Channel)